Unloading Auger Position-Adjusting (Standard Grain Tank)

causym CAUTION: Shut OFF engine, set parking brake and remove key.

1. With hydraulic cylinder fully retracted, check gap between plate (A) and stop (B).

Gap must be set to specification.

Specification

Plate to Stop -Gap 12-16 mm (1/2-5/8 in)

H80948


A-Plate
B-Stop

OUO6075,0000344 -19-13APR09-1/2

2. If gap is incorrect, adjust eyebolt (A).

3. Loosen jam nut (B) and set screw (C).

4. Adjust eyebolt to obtain correct gap

5. Tighten jam nut and set screw.


A-Eyebolt
B-Jam Nut
C-Set Screw

H66021

OUO6075,0000344 -19-13APR09-2/2