| |
Alfalfa |
Barley (Feed & Malting) |
| Feeder House Drum Position |
Down |
Down |
| Feeder House Conveyor Chain |
26 Tooth |
26 Tooth a |
| Feed Accelerator Speed b |
High |
High |
| Feed Accelerator Wear Strips |
Serrated |
Serrated |
| Threshing Speed (rpm) |
600-800 |
600-800 |
| Concave Clearance |
0-5 |
5-20 |
| Concave Type |
Small Wire |
Small Wire |
| Separator Grate Covers |
Use as required c |
Use as required c |
| Fan Speed (rpm) |
550-700 |
700-850 |
| Chaffer Settings |
10-20 mm (3/8-3/4 in.) |
19-22 mm (3/4-7/8 in.) |
| Sieve Settings |
1-3 mm (1/32-1/8 in.) |
6-9 mm (1/4-11/32 in.) |
| |
Beans (Edible) |
Canola (Canadian Spring) |
| Feeder House Drum Position |
Down |
Down |
| Feeder House Conveyor Chain |
22 Tooth d |
26 Tooth |
| Feed Accelerator Speed b |
Low e |
High |
| Feed Accelerator Wear Strips |
Backswept Serrated f |
Serrated |
| Threshing Speed (rpm) |
300-350 g |
350-650 |
| Concave Clearance |
10-30 |
10-30 h |
| Concave Type |
Round Bar/Large Wire |
Small Wire |
| Separator Grate Covers |
None |
Use as required c |
| Fan Speed (rpm) |
800-1100 |
500-700 |
| a32 tooth is recommended for high yielding, high volume poor feeding straw crops. |
| bFor improved straw quality in dry crops and grain quality, use low speed. |
| cIn shoe overloading conditions in dry crops, with small wire concaves, initially install two rows on right side and three rows on left side. Large wire concaves, initially install three rows on right side and two rows on left side. Adjust number and pattern as required by condition. |
| dAvailable through service parts. |
| eFor improved grain quality, use slow down kit to 320 rpm. |
| fBackswept wings can be installed for improved damage resistance. |
| gDo not operate below minimum speed recommendation. |
| hDo not operate above maximum concave clearance recommendation. |