|
Soybeans a |
Sunflowers (Oil) |
Feeder House Drum Position |
Down |
Down |
Feeder House Conveyor Chain |
26 Tooth |
26 Tooth |
Feed Accelerator Speed |
High b |
Low b |
Feed Accelerator Wear Strips |
Serrated |
Serrated |
Threshing Speed (rpm) |
450-650 |
300-400 c |
Concave Clearance |
15-25 |
30-40 |
Concave Type |
Round Bar/Large Wire |
Round Bar/Large Wire |
Separator Grate Covers |
None |
Use as required d |
Fan Speed (rpm) |
800-950 |
650-850 |
Chaffer Settings |
14-18 mm (9/16-11/16 in.) e |
13-15 mm (1/2-19/32 in.) |
Sieve Settings |
6-9 mm (1/4-11/32 in.) f |
7-9 mm (9/32-3/8 in.) |
|
Sunflowers (Confection) |
Wheat |
Feeder House Drum Position |
Down |
Down |
Feeder House Conveyor Chain |
26 Tooth |
26 Tooth g |
Feed Accelerator Speed b |
Low |
High |
Feed Accelerator Wear Strips |
Serrated |
Serrated |
Threshing Speed (rpm) |
300-400 c |
750-950 |
Concave Clearance |
30-40 |
5-20 |
Concave Type |
Round Bar/Large Wire |
Small Wire |
Separator Grate Covers |
Use as required d |
Use as required d |
Fan Speed (rpm) |
650-850 |
750-850 |
aIf harvesting corn and soybeans, it is not necessary to remove separator grate spacers. Remove spacers for all other crops. |
bFor improved straw quality in dry crops and grain quality, use low speed. |
cDo not operate below minimum speed recommendation. |
dIn shoe overloading conditions in dry crops, with small wire concaves, initially install two rows on right side and three rows on left side. Large wire concaves, initially install three rows on right side and two rows on left side. Adjust number and pattern as required by condition. |
eDeep tooth chaffer 10-12 mm (3/8-1/2 in.) |
fDeep tooth sieve 4-6 mm (5/32-1/4 in.) |
g32 tooth is recommended for high yielding, high volume poor feeding straw crops. |