Standard Speed High Capacity Feed Accelerator-Changing

NOTE: When changing separator speeds make sure to cycle power ON and OFF. Combine will now recognize the new speed range.

To change feed accelerator speed to high speed position:

  • Remove belt tension by pushing lever (A) up and out from notch in bracket (B).
  • Move belt (C) to inside sheave grooves on both sheaves for high speed.
  • Push lever up and into notch in bracket to reset belt tension.


A-Lever
B-Notch in Bracket
C-Belt

H74782
H86423

OUO6075,0000747 -19-16JUL07-1/1