|
1.
Disengage separator.
2.
Shut OFF engine, set parking brake and remove key.
3.
Shift separator drive gearcase to low speed.
4.
Remove belt tension from feed accelerator drive by pushing lever up and out from notch in bracket.
5.
Open stone trap door and clean. Leave stone trap door open.
6.
Sound horn, start engine and set engine speed at mid idle.
7.
Engage separator to clean out material, discharge beater and chopper.
8.
Disengage separator.
9.
Shut OFF engine, set parking brake and remove key.
10.
Remove feed accelerator access covers and remove crop material from accelerator area. After
|
clearing plug, rotate accelerator one revolution to be sure it is free.
11.
Engage feed accelerator drive by pushing lever up and into notch in bracket.
12.
Sound horn, start engine and set engine speed at mid idle.
13.
Engage separator. If plug does not clear, disengage separator and repeat steps 9 - 13.
14.
Shut OFF engine, set parking brake and remove key.
15.
Close stone trap door and set concave spacing back to original setting. Replace feed accelerator access covers.
16.
If initially operating in high speed, shift separator drive gearcase and adjust separator speed back to initial setting and resume operation.
|