Spreader to Windrow Position

CAUTION: Shut OFF engine, set parking brake and remove key. Before performing service or maintenance on raised spreader, fully insert lock-out pin into place.

IMPORTANT: Spreader hoop (A) should always be in the "down" position as shown while operating.

Spreader can be rotated upward into windrow position to allow material to discharge into a windrow.

A-Spreader Hoop

OUO6075,00007AB -19-23APR07-1/4

Raise spreader hoop (A) to locked position as shown to access spreader or when raising spreader to windrow position.

A-Spreader Hoop

OUO6075,00007AB -19-23APR07-2/4

Remove quick-lock pin (A).

Hold onto tube (B) and remove pin (C). Lower tube forward.

A-Quick-Lock Pin
B-Tube
C-Pin

OUO6075,00007AB -19-23APR07-3/4

Place pin (B) back into storage position and retain with quick-lock pin (A).

CAUTION: Before performing service or maintenance on raised spreader, fully insert lock-out pin (C) into place.

Raise spreader until pin (D) is fully engaged in the latch assembly (E).

NOTE: Set spreader speed to zero, refer to Spreader Speed Adjust Switch in CommandTouch Armrest Console section for further information.

A-Quick-Lock
B-Pin
C-Pin
D-Pin
E-Latch Assembly

OUO6075,00007AB -19-23APR07-4/4