Unloading Auger Drive Belt-Replacing

CAUTION: Shut OFF engine, set parking brake and remove key.

Be certain drive is disengaged and hydraulic cylinder (A) is retracted.

Loosen tensioner (B) on unloading auger drive chain.

Remove chain from driver sprocket (C) on countershaft.

Remove cap screws retaining belt trap (D).

Remove belt trap and belt (E).

Install replacement belt and replace belt trap previously removed.

Install drive chain and adjust idler until washer aligns with end of gauge.

A-Hydraulic Cylinder
B-Tensioner
C-Sprocket
D-Belt Trap
E-Belt

OUO6075,00007D1 -19-23APR07-1/1