|
Cleaning outside of machine
-
Wash outside of machine using a power washer.
-
Use a soft absorbent cloth to wipe off water droplets.
-
Use a good clear wax or glazing compound that contains no abrasives and lint free towel.
-
Apply wax or compound on a cloth and rub into panel in a circular motion. After compound is rubbed into panels, turn towel over and buff out with the other (dry) side.
Cleaning plastic parts:
NOTE:
Do not clean plastic parts with fuel or other petroleum based cleaners.
Always follow manufacturers directions when using cleaner and test on a small hidden area first.
-
Some machine trim parts are plastic. Use tar and road oil remover to remove dirt, wax buildup and other deposits.
Vinyl and plastic parts:
|
-
Remove dust and dirt with a whisk broom or vacuum cleaner. Clean vinyl surfaces with leather and vinyl cleaner.
-
Clean surfaces with clean, soft damp cloth.
-
For more thorough cleaning, wipe surface with soft cloth and mild detergent.
-
Remove excess detergent with clean dry cloth.
Cleaning Fabric:
NOTE:
Always follow manufacturers directions when using fabric cleaner and test on a small hidden area first.
-
Remove dust and loose dirt with whisk broom or vacuum cleaner.
-
Remove excess staining material by scraping or wiping with clean cloth.
-
For water soluble stains, use a damp cloth first, followed by a soft cloth with a mild detergent and water.
-
For grease, oil, tar or other petroleum based stains, apply fabric cleaner to soiled area following the manufactures directions.
|