Communications/CB Radio Mounting

IMPORTANT: Do not install a radio requiring more than 3 amps or electrical system may malfunction.

To install additional radio or CB radio, see your John Deere dealer.

Antenna mount (A) is located in center of cab roof. Antenna cable (B) is located on right-hand side of cab under the armrest console.

A-Antenna Mount
B-Antenna Cable

OUO6075,0000896 -19-19FEB07-1/3

Use provided dimensions (A) and (B) to locate bracket (C) behind interior panel.

Using bracket (supplied by radio manufacture) as a template, drill holes as required through foam and plate on right-hand rear inside cab. Use self tapping screws to mount bracket.

A-Dimension, 185 mm (7.25 in.)
B-Dimension, 225 mm (9 in.)
C-Bracket, 50 mm (2 in.)

OUO6075,0000896 -19-19FEB07-2/3

Remove right-hand cab wall plate (A) and plug (B). Obtain rubber grommet from John Deere dealer and cut grommet so antenna cable can be routed through grommet and cab wall plate.

NOTE: Do not leave grommet out or mice can enter cab area through this hole.

A-Cab Wall Plate
B-Plug

OUO6075,0000896 -19-19FEB07-3/3