OMHXE13769: 9670 STS and 9770 STS Combines 9670 STS 735201 9770 STS 735301 , Block File: OUO6075_0000AB1_19

Tough Crop (Rice) Feed Accelerator-Wing Replacing

causym CAUTION: Shut OFF engine, set parking brake and remove key.

Feed accelerator wings and wear strips can be replaced without removing the feed accelerator. Replace feed accelerator wings in sets of two and opposite of each other to maintain proper balance.

NOTE: If accelerator is removed from machine, or has been serviced, tighten clamp bolts before securing wings. Tighten cap screws to specification.

Remove round head bolts (A) and replace feed accelerator wear strips (B) as required. Tighten round head bolts to specification.

Specification

Feed Accelerator Wear Strip Round Head Bolts -Torque

90 N·m

(66 lb-ft)

Remove cap screws (C) and replace feed accelerator wings (D) as required. Tighten cap screws to specification.

Specification

Feed Accelerator Wing Cap Screws -Torque

70 N·m

(52 lb-ft)

Feed Accelerator Wing (Rice)

H79440

Feed Accelerator Wing (Rice)

A-Round Head Bolt(s)
B-Feed Accelerator Wear Strip
C-Cap Screws
D-Feed Accelerator Wings

OUO6075,0000AB1 -19-16JUL07-1/1