When to Calibrate
NOTE:
All Calibration:
See calibrations for your Header in your Combine Operator's Manual.
Calibration procedures must be performed before first use or if header height control sensor, deck plate position sensor or associated components are replaced.
-
Header Calibration -LC1 (hdr)
-
CONTOUR MASTER Angle Sensor Calibration - LC1 tilt (Optional)
-
Hydraulic Adjustable Deck Plate -LC1 (Optional) on a 50 and 60 Series Combines Sensor Calibration - dEc
-
Active Float Calibration - FLO
NOTE:
The condition causing the error must be corrected before the calibration can be continued.
If any errors occur during the calibration procedures, error codes will be displayed on the triple display tachometer, on 50 and 60 Series Combines and displayed on the Command Center Display on a 70 Series Combine.
|