When to Calibrate

IMPORTANT: Before performing header calibration:

• Completely raise platform
• Unlock and lower auxiliary sensor arms, if equipped (See AUTOMATIC HEADER HEIGHT CONTROL — RIGID MODE in OPERATING THE PLATFORM section)

NOTE: All Calibration: See calibrations for platform in your combine Operators Manual.

Calibration procedures must be performed before first use of platform, if header height control components have been serviced, or if switching from on-ground to off-ground mode.

• Header calibration -LC1 (hdr)
• Contour-Master™ angle sensor calibration - LC1 tilt (Optional)
• Active float calibration - FLO
• Feeder house calibration - see your combine Operators Manual for information and procedures

NOTE: Conditions causing errors must be corrected before continuing calibration.

If any errors occur during the calibration procedure, error codes are displayed at:

• S series combine — CommandCenter™ display
• 70 series combine —CommandCenter™ display