Lubrication Interval Chart

Lubrication Interval Chart
			50 Hours	200 Hours	400 Hours	1000 Hours or Five Years
Check Main Gearbox Oil Level			•
Check 90° Gearbox Oil Level *			•
Check Center Feed Gearbox Oil Level			•
Check Side Draper Gearbox Oil Level **			•
Lubricate Feed Drum Drive Shaft Grease Fitting			•
Lubricate Input Drive Shaft Grease Fitting			•
Lubricate Reel(s) Grease Fittings			•
Lubricate Telescoping Knife Drive Shaft *			•
Lubricate Auxiliary Sensor Arm Fittings (If Equipped)				•
Lubricate Knife Drive Slip Clutch Grease Fitting				•
Lubricate Feed Drum Drive Shaft Slip Clutch Grease Fitting				•
Lubricate Float Arm Pivot Grease Fittings				•
Lubricate Reel Lift Cylinders					•
Change Main Gearbox Oil						•
Change Center Feed Gearbox Oil						•
* Platform uses dual knife system, repeat procedure on each end except on 630FD single knife drive system.
** Does not apply to 630FD.

IMPORTANT: To avoid equipment damage and failure due to system contamination, always clean grease fittings before and after lubrication.

If a grease fitting is damaged or missing, replace it immediately.

IMPORTANT: When checking oil levels, always clean area around plugs before removal.

Always tighten plugs securely.