OMHXE94126

Symptom	Problem	Solution
Active Header Control Will Not Operate	Manual raise or lower does not work.	See your John Deere dealer.
	Active header control not enabled.	Enable active header control mode that is desired in display unit.
	Feeder house to header connector not connected or loose.	Connect properly.
	Header sensor not properly connected or damaged.	Connect or repair sensor.

Active Header Control Lowers But Will Not Raise

Defective active header control card.

See your John Deere dealer.

Active Header Control Raises But Will Not Lower	Defective active header control card.	See your John Deere dealer.
	Control shaft restricted.	Check for restriction.

System Cycles or Hunts	Height sensing sensitivity is too high.	Adjust sensitivity setting. See Calibrations and Settings section.
	Lateral tilt sensitivity is too high.	Adjust sensitivity setting. See Calibrations and Settings section.

System Fails Intermittently After Manually Raising Header Over Obstacle

System was deactivated.

To reactivate, press activation button in multi-function lever.

Header Raises or Lowers Too Slow or Too Fast

Incorrect drop rate adjustment.

Adjust drop rate (see combine Operator's Manual).

SS43267,00004C1-19-20150119