End of Season Service

IMPORTANT: Do not use high pressure washer spray directly on bearings or any other area that might be damaged by water. High pressure water can get past most seals and cause damage. Dry these areas, then lube and run combine.

CAUTION: Support the corn head with either the hydraulic cylinder safety stop or with blocks, or lower it to ground level.

1. Clean the corn head thoroughly. Chaff and dirt will draw moisture and cause rust.

2. Lubricate the corn head. Grease the threads on adjusting bolts.

3. Paint all parts from which paint has worn.

4. Use a polymer protectorate on the points, deck covers and end fenders.

5. If possible, shelter the corn head in a dry place.

6. Order repair parts needed for next season.

JK22594,00000B9 -19-09AUG06-1/1