Remove and Install Oil Pan

NOTE: Place pan under drain plug to capture oil. Dispose oil properly, do not reuse.

1. Remove drain plug (A).

IMPORTANT: Avoid damage to reusable seal on pan. Do not use sharp objects to pry between pan and corn head.

2. Remove cap screws and washers (B) and oil pan (C).

A-Drain Plug
B-Cap Screws and Washers
C-Oil Pan

KM00321,0000043 -19-02SEP08-1/3

NOTE: When retaining pan with cap screws, start in center and move outward.

3. Reinstall drain plug (A).

4. Clean all dirt and oil from side sheet where oil pan is mounted. Reinstall oil pan with cap screws and washers (B).

A-Drain Plug
B-Cap Screws and Washers
C-Oil Pan

KM00321,0000043 -19-02SEP08-2/3

IMPORTANT: Oil level should be checked with corn head on combine and row unit skids touching ground (approximately a 25 degree angle).

6. Fill pan with 80/90 weight gear oil or until oil is level with bottom of plug (B).

7. Install plug (B).

Specification

A-Cover
B-Fill Plug

KM00321,0000043 -19-02SEP08-3/3