Raising and Removing Center Gatherer Shields and Points.

1. Loosen cap screw (A) on the rear of the gatherer shield and raise stop (B) to the vertical position.

NOTE: Do not over tighten cap screw (A).

Specification

Gatherer Shield Stop Cap Screw -Torque 20 N·m (15 lb-ft)


A-Cap Screw
B-Stop

H85642
H85643

OUO6043,0001C83 -19-20MAY08-1/2

2. Raise point and retain using pin (A). Pull latch bar (B) and lift point.

3. IF EQUIPPED: Disconnect ACTIVE HEADER CONTROL sensor wiring harness connector (C) from main wiring harness connector. Connector is located inside of the deck cover, near the through hole. Cut tie band attached to the rear of the cover, and then pull connector out to access.

causym CAUTION: The center shield and point assembly is heavy and awkward to handle.

4. Slide the gatherer shield to right-hand side until shield is free of support pins (D), lift off point and gatherer shield assembly.


A-Pin
B-Latch Bar
C-Harness Connector
D-Support Pins

H89294
H90495
H91766

OUO6043,0001C83 -19-20MAY08-2/2