Using Instrument Panel

LV16682-UN-21FEB13

LV16683-UN-21FEB13

B - Tachometer - Shows engine speed. Engine speed is shown in 100s. Example: If indicator is pointing at 20 (20 x 100 = 2000 rpm).

Item	Measurement	Specification
Engine Idle
Low Idle	Speed	950 ± 25 rpm
Rated	Speed	2500 rpm
Fast Idle	Speed	2650 ± 50 rpm

C - Engine Coolant Temperature Gauge - Indicates temperature of cooling system. If gauge needle reaches red range, engine is overheating and engine RPM will derate.

If engine is overheated, remove load on machine immediately. Reduce engine to idle speed and allow engine to cool. Stop engine. Check coolant level in overflow bottle and check for air flow blockage to radiator. If coolant level is correct and needle stays in red range after cleaning grille, stop engine.

D - Right Turn Signal/Warning Flasher Indicator Light - Flashes when turn signal switch is moved to right turn position, or when light switch is turned to warning flasher lights ON or road position.

E - Service Alert Indicator - Illuminates when a malfunction occurs (review error message in Information Display). If necessary have John Deere dealer diagnose vehicle.

F - Front PTO Indicator Light - Illuminates when Front PTO is engaged (if equipped).

G - PTO Indicator Light - Illuminates when PTO switch is engaged.

H - Rear PTO Indicator Light - Illuminates when Rear PTO is engaged.

I - Parking Brake Light - Illuminates when ignition key is in ON position and parking brake is locked.

J - Not Used

K - Alternator/Battery Charging Light - Illuminates when ignition key is in ON position and engine is not running. If light turns on while engine is running, alternator is not charging battery. Move engine speed control lever to full throttle position. Stop engine if light remains on.

L - Information Display - Displays speedometer, hour meter, PTO hour, PTO speed, regen information and diagnostic trouble codes (if active).

M - Engine Glow Plug Indicator Light - Illuminates when ignition key is in ON position and engine glow plug reaches temperature. Glow plugs are energized whenever starter is engaged.

N - Engine Oil Pressure Light - Illuminates when ignition key is in ON position and the engine is not running. If this light turns on while engine is running, engine oil pressure is too low. Stop engine.

O - High Exhaust Temperature Indicator - Illuminates when the temperatures are high enough inside the exhaust filter to allow active filter cleaning.

P - Exhaust Filter Indicator - Illuminates when soot levels in the filter are high and exhaust filter cleaning is needed.

Q - Trailer 1 Indicator - Starts flashing when trailer turn signal or hazard warning lights are switched on (if equipped).

R - Trailer 2 Indicator - Starts flashing when trailer turn signal or hazard warning lights are switched on (if equipped).

S - Stop Indicator - Illuminates when a serious malfunction occurs, SHUT OFF engine IMMEDIATELY and determine cause (review error message in Information Display). If necessary, have John Deere dealer diagnose vehicle.

T - Vehicle Information Display - Shows vehicle wheel speed, engine hours, PTO speed, and diagnostic information.

U - PTO Icon - Illuminates when PTO is operating and PTO speed is displayed in the vehicle information display.

V - Hour Meter Icon - Illuminates when engine hours are being displayed in the vehicle information display.

W - Vehicle Information Display - Shows engine hours, PTO speed, and diagnostic information.