Using Rear Power-Take-Off (PTO)

IMPORTANT: Avoid Damage! Use rear mounted equipment rated for 540 rpm. Do not operate PTO over 540 rpm mark on tachometer.

NOTE: The PTO is only operational with the operator in the seat.

Engaging the PTO

1. 
   LV16737-UN-28FEB13

   A - PTO Engagement Switch

   Sit on operator seat.

---




2. Stop machine motion, remove foot from forward and reverse travel pedals.

3. NOTE: The starter will not crank if the PTO switch knob is pulled up into engaged/on position. If the operator leaves seat with engine running and PTO engaged, the safety interlock system will stop the engine.

   Reduce throttle setting to 1500 rpm.

4. Pull PTO knob to engaged/on position to engage PTO.

5. Adjust engine speed control knob forward to desired speed for implement use.

   NOTE: The PTO icon on the tachometer indicates correct engine rpm for a standard 540 PTO.

Disengaging the PTO

1. Adjust engine rpm to slow idle.

2. Push PTO switch knob down to the disengaged/off position.