Setting Height of Cut

NOTE: The label on the height-of-cut knob can be either numeric or symbolic.

NOTE: The numbers on the height-of-cut dial are for reference only. They do not represent a one-to-one ratio between the dial and the deck cutting height.

LVP11308
LVP11308-UN-09SEP20

Numeric Label (1 - family shown, 2 - family is similar)

LVP11154
LVP11154-UN-19AUG20

Symbolic Label (1 - family shown, 2 - family is similar)

A - Height-of-Cut Control

B - Install Position

The mower height-of-cut is adjusted with the control (A) on the left side of the operator. Raise and hold the mower to its highest position using either type of the lift system and adjust the mower cutting height knob as follows:

• Install (B) - Turn the control to this position to lower the mower lift mechanism whenever removal or installation of the mower is required.

NOTE: Do NOT lower lift system after adjusting the height-of-cut to the desired level.

• Height-of-Cut Range 1—4 or Low to High - Turn the control to any position in this range to select the desired height-of-cut.

UP00731,000010B-19-20201015