Store Attachment

NOTE: Not necessarily all the procedures are applicable to your attachments. Validate the steps with your product.

1. Remove attachment from the machine.

2. Clean attachment and driveline, if equipped.

3. To clean out all debris, remove any shields.

4. Repair or replace worn, bent, or damaged parts. Tighten loose hardware.

5. To prevent rust, do the following:

   1. Apply paint to painted surfaces if necessary.

   2. Apply thin coat of grease to blades.

   3. Lubricate any pivot points with engine oil.

   4. Lubricate any grease points.

6. IMPORTANT: Avoid damage! Abrasive surfaces can damage attachment. Store attachment on non-abrasive surface or on wooden blocks.

   If storing attachment outdoors, block up attachment if possible and place a waterproof cover over it.