Stop Machine

Normal Stop

1. Avoid crushing injury. Couple the brake pedals together when driving at higher speeds.

   Position the machine on a firm, level surface.

2. Stop motion by smoothly removing pressure from forward or reverse travel pedals.

3. Disengage the PTO switch.

4. Avoid crushing injury! Check that the area is clear of bystanders before lowering implements to the ground.

   Lower implements to the ground.

5. Avoid Damage! Do not stop the engine immediately after a hard or extended operation. Prevent heat buildup by running the engine at low idle for 2 minutes.

   Set hand throttle to the low idle position. Allow the engine to idle for 2 minutes.

6. Avoid crushing injury! Engage the park brake and move the transmission range lever to a position other than N (neutral) before leaving the machine unattended.

   Apply the park brake.

7. Turn the key switch to the stop position.

8. Remove the key.

9. Wait for the engine and all moving parts to stop before leaving the operator station.

Emergency Stop

1. Remove pressure from the forward or reverse pedal.

2. Depress the brake pedal.

3. Turn the key switch to the stop position. Do not release the brake pedal until all moving parts have stopped.

4. Apply the park brake.