OMLVU31190

Information Display Fault Messages

Symptom	Problem	Solution
“PTO Switch Fault” Message	Fault with the PTO circuit	See a John Deere dealer

“PTO Coil Fault” Message

Fault with the PTO Solenoid

See a John Deere dealer

“Pull Coil Fault” Message

Fault with fuel shut off circuit

See a John Deere dealer

“Hold Coil Fault” Message

Fault with fuel shut off circuit

See a John Deere dealer

“Start Coil Fault” Message

Fault with starting circuit

See a John Deere dealer

“RIO Fault” Message

Fault with RIO circuit

See a John Deere dealer

“Audible Alarm Fault” Message

Fault with information display audible alarm

See a John Deere dealer

“Engine Overheat” Message	Coolant level is below specification	Add coolant to specification
	Leak in coolant system	Check for leaks and repair or see your John Deere dealer
	Improperly adjusted or broken fan belt	Tighten or replace fan belt
	Dirt or debris accumulation on hood screen or radiator	Clean debris and dirt from front screen and radiator fins

“Low Fuel” Message	Fuel level low	Fill fuel tank
	Fault with fuel sensing circuit	See a John Deere dealer

“Hydraulic Oil Overtemp” Message	Water in hydraulic oil	Replace hydraulic oil with correct oil type or see a John Deere dealer
	Plugged hydraulic oil filter	Replace oil filter
	Improper type of hydraulic oil	Verify correct hydraulic oil. Drain system and fill with correct oil type
	Oil leaks	Check for leaks and repair or see your John Deere dealer

“Air Filter Restriction” Message	Plugged air filter	Replace air filter elements
	Plugged inlet air filter suction pipe	Clean debris from suction inlet tube

UP00731,0000327-19-20160912