Check and Adjust L-Pin Engagement

Avoid damage! If L-pins are not properly engaged, broom could slide out of position on quick hitch. Check engagement of L-pins before operating and adjust as needed.

Check the L-Pin Engagement

LV27775-UN-23FEB17

A - L-Pin

1. Make sure both L-pins (A) pass completely through the holes in the broom mounting frame.

2. Push the broom as far as possible to the right and left. Make sure the L-pins remain in the mounting frame holes.

3. Reverse the installation if the L-pins disengage or do not pass completely through the holes in the mounting frame.

Reverse the L-Pins

LV27563-UN-02FEB17

A - Roll Pin

B - Bracket

C - Remove Spring

D - Short Leg

E - Long Leg

1. Remove the broom from the front quick hitch.

2. Remove the roll pin (A) using a punch. Retain the roll pin.

3. Pull the L-pin from the bracket (B) and remove the spring (C).

4. The L-pin legs are different lengths. Short leg (D) is 23 mm (0.9 in) and long leg (E) is 27 mm (1.1 in).

   Hold the spring inside the bracket. Reverse the L-pin and insert the long leg (E) through the bracket and spring.

5. Install the roll pin.

6. Repeat for the other L-pin.

7. Install the broom on front quick hitch.

8. Push the broom as far as possible to the right and left. Make sure the L-pins remain in the mounting frame holes.