Inspect ROPS for Loose Hardware

Make certain all parts are reinstalled correctly if the roll-over protective structure (ROPS) is loosened or removed for any reason. Tighten mounting bolts to proper torque. The protection offered by ROPS will be impaired if ROPS is subjected to structural damage, is involved in an overturn incident, or is in any way altered by welding, bending, drilling, or cutting. A damaged ROPS should be replaced, not reused.

LV27773-UN-20FEB17

A - Nut (3 each side)

B - Nut

C - Bolt (2 each side)

D - Bolt (2 each side)

Check all ROPS attaching hardware for tightness. Torque to the specification listed if loose.

Nuts (A)	Torque	120 N·m +/- 12 N·m 89 lb·ft +/- 9 lb·ft
Nuts (B)	Torque	485 N·m +/- 49 N·m 358 lb·ft +/- 36 lb·ft
Mounting Bolts (C)	Torque	490 N·m +/- 98 N·m 362 lb·ft +/- 72 lb·ft
Mounting Bolts (D)	Torque	120 N·m +/- 12 N·m 89 lb·ft +/- 9 lb·ft