Transport Machine

Driving Machine Safely on Roads

Avoid Injury! Use caution when operating machine at transport speeds. Reduce speeds if towed load weighs more than machine. Consult towed equipment operator’s manual for recommended transport speeds.

Use additional caution when transporting towed loads under adverse surface conditions, especially when turning, and on inclined surfaces.

Use of warning lights and turn signals are recommended when traveling on public roads unless prohibited by state or local regulations. An implement safety lighting kit is available from your John Deere dealer.

Observe the following precautions when operating the machine on a road:

• Make sure SMV (Slow Moving Vehicle) emblem and warning lights are clean and visible. If towed or rear mounted equipment obstructs these safety devices, install SMV emblem and warning lights on equipment.
• Turn on flashing warning lights and headlights, except if prohibited by law.
• Drive slowly enough to maintain safe control at all times. Slow down for hillsides, rough ground, and sharp turns, especially when transporting heavy, rear-mounted implements.
• Adjust tread width position of rear wheels to provide maximum stability.
• If equipped, disengage the MFWD to reduce tire wear.
• Never coast machine downhill.

Pushing or Towing Machine

1. Avoid Injury! Never tow machine faster than 16 km/h (10 mph). If possible, have someone operate steering and brakes of towed tractor.

   Avoid Damage! Push or tow machine for short distances only.

   Push PTO switch knob to the disengaged/off position.

2. Disengage differential lock.

3. Disengage park brake.

4. Place transmission range shift lever in the N (neutral) position.

5. Disengage the MFWD.