Use Display Mode Switch

LV22250
LV22250-UN-23JUN14

A - Display Mode Switch

The display mode switch (A) can be used to scroll through hour meter and active error codes display on all machines. The display information changes automatically as long as the display mode switch is pressed in the current cycle.

By intermittently pressing the display mode switch you can scroll through the functions in the following order.

  1. Engine hour meter
  2. Ground speed on all models, excluding PRT tractors
  3. Vehicle hour
  4. PTO hour
  5. Soot percentage
  6. Hour since last regeneration

Adjust Backlighting

  1. Press and hold the display mode switch for approximately 5 seconds to enter command mode.

  2. The display shows “rELEAS”, then “NIGHT”.

  3. Press the display mode switch again to accept.

  4. To toggle between the digits on the instrument panel, press the left turn signal.

  5. To toggle to the desired illumination, press the right turn signal. The range for illumination is 1—100.

  6. Press the display mode switch again to exit command mode.

Adjust Ground Speed Unit

  1. Press and hold the display mode switch for approximately 5 seconds to enter command mode.

  2. The display shows “rELEAS”, then “UNITS”.

  3. Press the display mode switch again to accept.

  4. Use the left or right turn signal to toggle between “km/h” and “mph”.

  5. Press the display mode switch again to exit command mode.

UP00731,00003F9-19-20170908