Fill Cooling System

Avoid damage! Using incorrect coolant mixture can damage the radiator:

• Do not operate engine with plain water.
• Do not exceed a 50% mixture of coolant and water.
• Aluminum engine blocks and radiators require approved ethylene glycol-based antifreeze.

John Deere Cool-Gard™ coolant is recommended when adding new coolant to the cooling system.

Follow the directions on the container for the correct mixture ratio.

1. Allow radiator to cool.

2. Fill cooling system.

3. Install and tighten radiator cap.

4. Run engine until it reaches operating temperature.

5. Stop engine.

6. Check coolant level in the recovery tank and add coolant if necessary

7. Lower hood.