Starting the Engine
CAUTION: Engine exhaust fumes contain carbon monoxide and can
cause serious illness or death. Move the machine to an
outside area before running the engine.
Do not run an engine in an enclosed area without adequate ventilation.
-
Connect a pipe extension to the engine exhaust pipe to direct
the exhaust fumes out of the area.
-
Allow fresh outside air into the work area to clear the exhaust
fumes out.
NOTE: Engine will not start unless park brake is applied and
mower is disengaged.
-
Sit on seat.
-
Make sure mower engagement lever is disengaged.
-
Push down brake pedal.
-
MXAL45982-UN-09APR13
Check starting conditions:
If engine is cold:
-
Move throttle lever (A) between the half throttle and fast
throttle positions, and move choke lever (B) up to the choke position.
If engine is warm:
-
Move throttle lever (A) to the half throttle position, and move
choke lever (B) half way up or do not use at all depending on engine
temperature.
-
IMPORTANT: Starter may be damaged if starter is operated for
more than 20 seconds at a time:
-
Wait two minutes before trying again if engine does not start.
-
Refer to Ignition Interlock System or Sit-on-Seat Diagnostics
in this section or the Troubleshooting section if engine will not
start.
Turn key (C) to start position for no more than 5 seconds.
-
Release key to run position and gradually release choke lever
down to the off position when engine starts. If engine does not start:
-
Wait 10 seconds.
-
Turn key to start position again for no longer than 5 seconds.
Release key and choke lever when engine starts.
-
Repeat procedure if necessary.
-
IMPORTANT: Unnecessary engine idling may cause engine damage.
Excessive idling can cause engine overheating, carbon build-up, and
poor performance.
Run engine at half throttle for 30-60 seconds to allow warm-up
before operating.
|
SP66632,000448C-19-20130913
|
|