Removing Mower (38 and 42C Mower)
-
Park machine safely. (See Parking Safely in the SAFETY section.)
-
Allow engine and muffler to cool completely.
-
CAUTION: Rotating blades are dangerous. Before adjusting or
servicing mower:
-
Disconnect spark plug wire(s) or battery negative (-) cable
to prevent engine from starting accidently.
-
Always wear gloves when handling mower blades or working near
blades.
Adjust mower cutting height to lowest position.
-
CAUTION: If the lift pedal is spring-assisted it may have unexpected
movement. Lock the lift pedal when installing or removing
mower deck.
NOTE: If the machine is equipped with a lift assist spring,
lower the deck and then pull lift pedal back by hand to lock the lift
lever.
Lower mower deck, pull back lift pedal by hand, and pull lift
lever up to lock.
-
CAUTION: Component is spring-assisted and under tension. Injury
can occur if spring-assisted component is released suddenly.
MXAL46019-UN-09APR13
42C deck shown.
Using a 3/8 in. ratchet, rotate and hold tension arm (A),
under left side of fender deck, rearward (B), while removing mower
belt from engine sheave (C).
-
MXAL46020-UN-09APR13
42C deck shown.
Remove locking clip (D) and pin (E), and move rear draft
arm (F) away from deck bracket (G). Raise deck slightly with deck
handle to remove pressure on pin when pulling out. Repeat on other
side.
-
MXAL46021-UN-09APR13
Remove front draft rod (H) from mower bracket (I).
-
When operating the machine without the mower deck:
-
Remove locking clip (J) from stud (K) on each side, and remove
front draft rod from draft bracket (L). Note orientation of stud offset
when removing, correct offset is above rod.
-
Raise draft arms to transport position:
-
Pull and hold lift pedal by hand.
-
Unlock lift latch handle.
-
Push lift pedal downward.
-
Pull up latch handle to lock draft arms in transport position.
-
Slide mower out from under the machine.
|
SP66632,00044B9-19-20130416
|
|