-
Park machine safely. (See Parking Safely in the SAFETY section.)
-
Allow engine and muffler to cool completely.
-
CAUTION: Rotating blades are dangerous. Before adjusting or
servicing mower:
-
Disconnect spark plug wire(s) or battery negative (-) cable
to prevent engine from starting accidently.
-
Always wear gloves when handling mower blades or working near
blades.
Adjust mower cutting height to lowest position.
-
MXAL46030-UN-09APR13
42C deck shown
Slide mower deck under tractor and line up deck bracket (A)
with draft arm (B).
-
Unlock lift latch handle.
-
CAUTION: If the lift pedal is spring-assisted it may have unexpected
movement.
Lock the lift pedal when installing or removing
mower deck.
Pull lift pedal by hand to lower draft arms. Hold pedal securely
and lock lift latch handle.
-
MXAL46419-UN-05APR13
Install front draft rod (C) into mower bracket (D).
If draft rod assembly has been removed from machine:
-
Install mounting stud (E) into draft bracket (F) at each side.
Note orientation of stud offset when installing, correct orientation
is for stud to be offset above draft rod.
-
Secure each side with locking clip (G).
-
Install draft rod into mower bracket.
-
MXAL46032-UN-09APR13
42C deck shown
Install pin (H) through deck bracket (A) and draft arm (B).
Make sure pin installs completely through deck bracket. Secure pin
with locking clip (I). Repeat for other side.
-
CAUTION: Component is spring-assisted and under tension. Injury
can occur if spring-assisted component is released suddenly.
IMPORTANT: The belt will be damaged if installed wrong. Route
the belt properly through belt guides. See belt routing label on mower
deck.
MXAL46033-UN-09APR13
42C deck shown
Using a 3/8 in. ratchet, rotate and hold tension arm (J),
under left side of fender deck, rearward (K), while installing mower
belt onto engine sheave (L).
-
Level mower.