Adjusting Cutting Height

Cutting height can be adjusted from approximately 25-100 mm (1-4 in.). When mower deck is in transport position cutting height is approximately 100 mm (4 in.).

  1. Check tire pressure and adjust as needed.

  2. MXAL47046
    MXAL47046-UN-16APR13

    MXAL47047
    MXAL47047-UN-16APR13

    Z600 series shown.

    Raise mower deck:

    • Z425, Z445 and Z465 - Pull upward on mower deck lift lever (A) and pull lever towards center of machine to lock in raised position.
    • Z600 Series (48, 54, and 60 in. HC Deck) - Push down on lift pedal (B), and pull upward on mower deck lift lever (A) until in fully raised position.



  3. Insert the pin (C) in the proper hole for the desired height of cut.

  4. Lower mower deck:

    • Z425, Z445 and Z465 - Lift slightly on mower deck lift lever, push slightly outward, and lower lift lever (A) onto pin (C).
    • Z600 Series (48, 54, and 60 in. HC Deck) - Place foot on lift pedal (B) and release lift pedal rearward while lowering mower deck lift lever (A) onto pin (C).

MX00654,000032B-19-20130602