Replacing Mower Drive Belt (60HC)

1. Park machine safely. See “Park Machine Safely” in the Safety section.

2. Allow engine and muffler to cool completely.

3. Remove mower deck.

4. CAUTION: Components are installed under spring tension. Wear eye protection and use proper tools when installing and removing components with spring tension.

   
   MXAL47126-UN-16APR13

   Remove six bolts (A) and left and right belt covers (B).

---




5. 
   MXAL47127-UN-16APR13

   Unhook tensioning spring (C) from deck anchor bracket (D).

---




6. Remove threaded belt guide (E) to remove belt from idler sheave (F).

7. Loosen four nuts (G) enough to tilt guides (H) for clearance to remove belt from outer sheaves.

8. Remove guide screw (I).

9. Remove belt from all sheaves.

10. Inspect belt for wear or damage; replace as necessary.

11. Clean top surface of mower deck and sheaves.

12. Install belt on mower deck as shown.

13. Hook tensioning spring to deck anchor bracket.

14. Pivot belt guides to correct position and tighten nuts to secure. Tighten idler sheave bolt (E) nut to specification.

    Item	Measurement	Specification
    Idler Sheave Bolt	Torque	47 N·m (35 lb-ft)

15. NOTE: Failure to seat belt properly on sheaves may result in belt damage.

    Make sure belt is properly seated on all sheaves, and install belt shields.

16. Install mower deck.