Replacing Mower Drive Belt (62 Inch Mower)

  1. MXAL47128
    MXAL47128-UN-16APR13

    Loosen eight bolts (A), and remove right and left belt covers (B).



  2. MXAL47129
    MXAL47129-UN-16APR13

    Unhook tensioning spring (C) from deck anchor bracket.



  3. Loosen nut (D), securing idler pulley belt guide (E) enough to tilt guide off pulley bolt. Pivot belt guide for clearance.

  4. Loosen nut (F) securing belt guide (G) and tensioner pulley (H).

  5. Remove belt from all sheaves

  6. Inspect belt for wear or damage; replace as necessary.

  7. Clean top surface of mower deck and sheaves.

  8. Install belt on mower deck as shown.

  9. Hook tensioning spring to deck anchor bracket.

  10. Pivot belt guides to correct position and tighten nuts to secure. Nut (F) on tensioning pulley should be tightened to specification.

    ItemMeasurementSpecification
    Tensioning Pulley NutTorque47 N·m (35 lb-ft)

  11. NOTE: Failure to seat belt properly on sheaves may result in belt damage.

    Make sure belt is properly seated on all sheaves, and install belt shields.

  12. Install mower deck.

MX00654,000034C-19-20130603