Removing Mower Deck (48C and 54C)

  1. Park machine safely. (See Parking Safely in the SAFETY section.)

  2. Allow engine and muffler to cool completely.

  3. CAUTION: Rotating blades are dangerous. Before adjusting or servicing mower:

    • Disconnect spark plug wire(s) or battery negative (-) cable to prevent engine from starting accidently.

    • Always wear gloves when handling mower blades or working near blades.

    Raise mower deck to the transport lock position.

  4. MXAL47104
    MXAL47104-UN-16APR13

    (Z425 shown)

    Remove lock pin, push handle to its lowest position (A) and install pin just above lever (B) to lock deck in lowered position.



  5. Remove foot plate.

  6. Disconnect mower drive belt:

    CAUTION: Component is spring-assisted and under tension. Injury can occur if spring-assisted component is released suddenly.

    • MXAL47105
      MXAL47105-UN-16APR13

      48C shown. 54C similar.

      Install 3/8-inch ratchet onto square hole (C) in tension arm and rotate clockwise to release tension on belt, while removing mower belt from center spindle sheave (D).

    • Remove belt from engine sheave.



  7. GXT001421
    GXT001421-UN-19MAY14

    Remove locking clips (E), and remove front draft rod (F) from draft brackets (G) and mower deck brackets (H).



  8. MXAL47107
    MXAL47107-UN-16APR13

    Remove spring clip (I) and pin from each side of rear mower bracket.



  9. Raise draft arms to transport position:

    1. Pull and raise mower lift lever fully upward.

    2. Install pin just below lift lever to lock into raised position.

  10. Rotate front caster wheels to maximize clearance.

  11. Slide mower out from under the machine.

    • Do not operate the machine without the mower deck: Machine may become unstable without the mower deck attached. Move machine only by hand. (See Moving Machine by Hand in OPERATING section.)

TH84124,0000116-19-20140519