Install Seat (Standard Models)

MXT010946-UN-01AUG14

1. Route wiring harness (A) through hole in fenderdeck (B) and hole in seat base (C).

2. IMPORTANT: Make sure to set both springs at same location in channels.

   
   MXT010945-UN-01AUG14

   Install seat (A) onto seat base and secure with pin (B) and locking pin (C).

---




3. Insert springs (D) into channels.

   • Move springs (D) to front position for softest ride.
   • Move springs (D) to middle position for average ride.
   • Move springs (D) to rear position for firm ride. NOTE: Additional suspension coils can be installed for extra support. See your John Deere dealer.
     
   
   

4. Connect wiring harness connector (E) to seat switch connector (F).