Adjusting and Lubricating Drive Chain

  1. Avoid injury! Do not operate snow removal attachment without chain shield.

    Park machine safely. (See Parking Safely in the SAFETY section.)

  2. Disconnect drive shaft from machine.

  3. MXT013826
    MXT013826-UN-24MAR15

    Move chain shield (A) left to provide tension on the chain. Deflection should be 4.7—10 mm (3/16—3/8 in.).



  4. Adjust chain, if necessary:

    • Loosen four locknuts (B) on chain shield.
    • Slide chain shield right or left until deflection measurement is right.
    • Hold chain shield in place and tighten nut.

  5. Rotate auger several turns and make sure that chain has at least 4.7 mm (3/16 in.) deflection at all times.

  6. Lubricate chain with John Deere TY 6240 Chain Lube Spray or equivalent.

  7. Start engine. Run snowblower briefly to distribute oil.

  8. Stop engine. Wipe off excess oil.

  9. Check condition of chain and sprockets. Replace if necessary.

MX52301,0000A20-19-20150526