Install Front Lift Assembly

1. Park machine safely. (See Parking Safely in the SAFETY section.)

2. Raise the tractor lift arms to the highest position.

3. Set Height-of-Cut knob to lowest position.

4. CAUTION: Avoid injury! Lift pedal is spring-assisted and can have unexpected movement. Lock lift pedal when installing or removing attachment.

   
   MXT007403-UN-06JUN13

   Lower lift arms—Foot Lift:

   1. Pull lift pedal (A) back by hand to lower linkage to the lower/down position.

   2. Pull lock lever (B) up to lock linkage in the lowered position.

---




5. 
   MXT013992-UN-18JUN15

   Lower lift arms—Hydraulic Lift:

   a. Push down on lift lever (C).

---




6. 
   MXT013976-UN-16JUN15

   Picture Note: Rear lift bracket to left-hand lift arm shown.

   D - Bracket, Rear Lift

   E - Lift Arm

   F - Weld Pins

   G - Cotter Pin, Self-Locking

   Install rear lift bracket:

   1. Install bracket (D) onto the left-hand lift arm (E) by inserting the weld pins (F) into the holes on the lift arm.

   2. Install self-locking cotter pins (G).

   ---

   
   

   3. 
      MXT013977-UN-16JUN15

      Picture Note: Rear lift bracket to right-hand lift arm shown.

      H - Holes

      I - Bracket, Rear Lift

      J - Lift Arm

      K - Pin, Clevis

      L - Cotter Pin, Self-Locking

      Align holes (H) on bracket (I) with the holes on right-hand lift arm (J).

   4. Insert pins (K) through the lift arm and bracket.

   5. Install self-locking cotter pins (L).

---




7. 
   MXT013993-UN-18JUN15

   M - Hitch, Front Attachment

   N - Front Draft Assembly

   O - Pin, Front Draft

   P - Spring Locking Pin, 4.5 mm

   Align hole in hitch (M) with the hole in front draft assembly (N).

---




8. Install 300 mm (11.8 in.) pin (O) and large spring locking pin (P).

9. 
   MXT013994-UN-18JUN15

   Picture Note: Lift link to left side of hitch shown.

   Q - Flattened End

   R - Weld Pin

   S - Hitch, Front Attachment

   T - Cotter Pin, Self-Locking

   Install lift links:

   1. Install flattened end (Q) of lift link onto weld pin (R) inside the hitch (S).

   2. Install self-locking cotter pin (T).

   3. Repeat steps a and b to install second lift link onto the other side of the hitch.

   ---

   
   

   4. 
      MXT013980-UN-07AUG15

      U - Swivel Boss

      V - Bracket, Rear Lift

      W - Locknut

      X - Spring Locking Pin, 3.72 mm

      Pivot front hitch up until swivel boss (U) aligns with hole in bracket (V). Adjust lock nut (W) if necessary.

   5. Insert swivel boss into hole and install spring locking pin (X).

   6. Repeat steps d and e to finish installation of second lift link.

---