Towing the Sprayer Without Quick-Disconnect Option

IMPORTANT: Towing the 6700 Sprayer is not recommended without using factory design towbar or damage may occur. The 6700 Sprayer should only be towed if the machine is stuck or cannot move under its own power. It should only be towed a short distance at very slow speeds of 0 to 5 kph (0 to 3 mph).

To prevent machine damage, always disengage planetary hubs if towing.

CAUTION: Avoid serious injury or death to you or others. To prevent machine from rolling, engage and disengage hubs only when machine is attached to towing vehicle.

Remove two cap screws (A) and reverse center plate (B) so projection depresses hub center pin (C). Replace cap screws and tighten evenly, alternating one turn on each bolt until center plate is tight.

NOTE: Disconnecting drive motors allows all wheels to turn free. Reverse center plates after towing to engage motors and return drive system to normal operation.

A-Cap Screws
B-Center Plate
C-Hub Center Pin

AG,OUO1011,257 -19-27APR99-1/1