Replace Cab Primary Filter Element

1. Remove two hold-down screws (if equipped), one on each side of roof. Unscrew thumb screw (A).

2. Lift roof. Remove rod (B) from storage clips. Insert bottom of one-piece support rod into molded-in support hole (C) of inner roof and install spring pin (D).

3. Unlatch clips (E) on both sides and remove filter element (F).

4. Install filter element using reverse procedure.

A-Thumb Screw
B-Rod
C-Support Hole
D-Spring Pin
E-Filter Clips
F-Filter Element

AG,OUO1011,269 -19-27APR99-1/1