Setting Manual Boom Charge Pressure

The boom charge pressure which the operator wants to spray for the initial 3 seconds after the master "ON" switch is pressed is the same pressure as the manual pressure setting.

To set manual boom charge pressure.

1. Set the manual pressure setting to the desired manual boom charge pressure by pressing "RUN".

2. Turn rate select knob (A) to "M".

IMPORTANT: It is recommended to set manual boom charge manual pressure setting at the pressure where the machine will be operating most of the time.

3. Press "D" to input manual target/boom charge pressure.

A-Rate Select Knob

AG,OUO1011,315 -19-28APR99-1/1