Aligning Wing Assemblies

1. With boom unfolded and in the working position, check alignment of the intermediate section with the center frame.

2. With fold cylinder pressurized, determine if the intermediate section needs to be adjusted to the front or rear to come into alignment with center frame.

NOTE: Because of adjustments to be made later, it is better to start with the wing assemblies angled slightly to the rear.

3. Relieve pressure from cylinder by folding boom inward a few inches.

4. Loosen jam nut (A) and cap screw (B) on back side of brace (C).

5. Turn adjusting nut (D) clockwise to move boom forward, or counter-clockwise to move boom rearward.

6. Tighten jam nut and cap screw.

A-Jam Nut
B-Cap Screw
C-Brace
D-Adjusting nut

AG,OUO1011,374 -19-29APR99-1/1