Adjusting Rear Cable

CAUTION: Rear cable can snap and injure you or someone else if tensioned when the boom is unfolded. Always adjust front cable first with the boom unfolded and rear cable last with the boom folded into transport position.

1. Raise boom to its highest position. Fold boom to transport position with tilt cylinders fully extended. Make sure fold cylinders are pressurized and that boom is folded all the way in.

2. Loosen jam nuts (A) and adjust turnbuckle (B) so outer boom section contacts rubber stop (C) on intermediate boom section. After boom section contacts stop, adjust turnbuckle two more full turns and tighten jam nuts.

A-Jam Nuts
B-Turnbuckle
C-Rubber Stop

AG,OUO1011,381 -19-29APR99-1/1