Filling Foam Marker Tank

CAUTION: Contents under pressure. Vent pressure from tank prior to removing cap or servicing foamer unit. Pull up on relief valve ring on cap to vent tank.

1. Pull up on ring on relief valve (A) to vent tank.

2. Remove cap and fill tank half full of water.

NOTE: Use John Deere foam concentrate for best results.

Shake foam concentrate, before adding to tank. Store concentrate in a warm place, where it will not freeze.

3. Refer to container for ratio mix and add recommended amount of foam concentrate.

4. Fill tank. If filling tank from bottom is preferred, open vent valve (B), attach hose to fill port (C) and fill. Close vent valve.

A-Relief Valve
B-Vent Valve
C-Port

AG,OUO1011,394 -19-29APR99-1/1