OMN200815 : 6700 Self-Propelled Sprayer, Block File: AG_OUO1011_457_19

1. Clean machine thoroughly, inside and out. (See CLEANING VEHICLE OF HAZARDOUS PESTICIDES in this section.)

2. Clean and flush solution system. (See CLEANING SOLUTION SYSTEM in this section.)

AG,OUO1011,457 -19-30APR99-1/5

3. Open drain cock (A) to drain solution pump.

4. Remove, clean and reinstall line strainer(s) and flowmeter. (If equipped.)

5. Remove and clean nozzle tips and screens. Store tips and screens off the machine, in a dry place.

A-Drain Cock

V-Tank Shown

AG,OUO1011,457 -19-30APR99-2/5

6. Remove monitor and store in a warm, dry place.

AG,OUO1011,457 -19-30APR99-3/5

7. Drain hydrostatic/hydraulic oil reservoir and replace filter (A).

8. Put 75 mL (2.5 oz) of corrosion inhibitor into reservoir and refill to proper level.

9. Cycle all hydraulic functions to distribute corrosion inhibitor to all components.

A-Filter

AG,OUO1011,457 -19-30APR99-4/5

10. Remove plug (A) and drain planetary hub. Install plug.

11. Remove plug (B) and add 30 mL (1 oz) of corrosion inhibitor in each planetary hub and refill to proper level. Install plug.

12. Drive machine to distribute corrosion inhibitor.

13. Lubricate all grease fittings. Apply grease to exposed area of hydraulic cylinder rods.

14. Repaint as necessary to prevent rust.

15. Block machine up to take weight off tires. Do not deflate tires.

16. Following label directions, apply John Deere Equipment Coating to keep machine clean and reduce chemical staining and corrosion damage.

A-Drain Plug
B-Level Plug

AG,OUO1011,457 -19-30APR99-5/5