Machine Specifications-6700

Item Specification
ENGINE
Manufacturer John Deere
Model 4045T Turbocharged
Number of Cylinders 4
Bore 106 mm (4.19 in.)
Stroke 127 mm (5.0 in.)
Displacement 4.5 L (276 cu. in.)
Horsepowera 79 kW (106 hp)
Compression Ratio 17.0 to 1
Firing Order 1-3-4-2
Type of Fuel No. 1-D or 2-D Diesel
Fuel System Filtered, Direct-Injection, with Diaphragm-Type Fuel Pump
Air Cleaner Dry-Type with Safety Element
Engine Speeds
Slow Idle 800-825 rpm
Fast Idle (No load) 2375-2400 rpm
ENGINE COOLING SYSTEM
Type Pressurized
Pressure 68 kPa (0.7 bar) (10 psi)
Thermostat 82.2°C (180°F)
ENGINE LUBRICATION
Oil Filter Full Flow
Type Spin-on
Protection Bypass Valve
DRIVE SYSTEM
Type Variable Hydrostatic Pump with Two Speed Motors and Planetary Gear Reduction Hubs
Ground Speeds (Engine at Rated Speed)
1st Gear (Low Range) 0-16 km/h (9.9 mph)
2nd Gear (High Range) 0-29 km/h (18.5 mph)
Towing Speed (Max) 32 km/h (20 mph)
aMaximum factory observed engine power (net less fan) at 2200 engine rpm.

 

AG,OUO6017,628 -19-10MAY99-1/5


BRAKES
Type Dual Actuating
Operationb (Travel) Foot Pedal
(Parking) Lever and Cable
bIndividually or locked together.

 

Item Specification
FINAL DRIVES
Type Planetary Gear Reduction Hubs
Lubrication Oil Bath
ELECTRICAL SYSTEM
Battery Voltage 12 Volts
Battery BCI Group 31
Battery Cold Cranking Amps @ -18°C (0°F) 750
Battery Specific Gravity Full Charge (corrected to 27°C (80°F) 1.250 (±0.10)
Battery Terminal Grounded Negative
Alternator 120 amps, Voltage Regulated
Headlight Bulb Halogen
Tail Light Bulb Mfg. Type 1157
Warning Light Bulb Mfg. Type 1156
Flood Light Bulb (Optional Rear) Halogen Type H7610
Field Light Bulb (Front) Type 4460
HYDRAULIC SYSTEM
Type Open Center
Pump Gear type, 57 Lpm (15 gpm)
Rated Working Pressure 16548 kPa (165 bar) (2400 psi)
Auxiliary Attachment Rating 34 Lpm @ 12065 kPa (10 gpm @ 1750 psi)
BOOM LIFTING MECHANISM
Type Hydraulically Operated Arms
Lift Height 1.07 m (42 in.)
Lowest Position (from ground) 1.67 m (65.6 in.)
Lift Arms Rotational Arc 68°
Lifting Capacity 681 kg (1500 lbs)
Lift Cycle Time 5.0-6.0 Seconds
Lift Cylinders
Quantity 2
Type Single Acting
Operating Height
18.3 m (60 ft.) Front Fold 610-2438 mm (24-96 in.)

 

AG,OUO6017,628 -19-10MAY99-2/5


STEERING SYSTEM
Type Hydrostatic
Relief Pressure 8619 kPa (86.2 bar) (1250 psi)
Control Wheel Valve
Operation Double Acting Cylinder
Turning Radius (4-Wheel) 5 m (16.5 ft)
Turning Radius (3-Wheel) 4.2 m (13.7 ft)

 

Item Specification
CAPACITIES
Fuel Tank 170 L (45 gal)
Cooling System w/Heater 19 L (20 qt)
Crankcase (including filter) 11.3 L (12 qt)
Hydraulic Reservoir (full to sight glass) 34.5 L (9.12 gal)
Hydraulic System 45.4 L (12 gal)
Final Drives (each side) 1390 mL (47 oz)
TIRES
Rear 12.4-38.8PR
Front (4-Wheel) 7.50-20, 6PR
Front (Narrow) (3-Wheel) 11L-15, 8PR
Air Pressure
Front (Wide) (4-Wheel) 179 kPa (1.8 bar) (26 psi)
Front (3-Wheel) 303 kPa (3.0 bar) (44 psi)
Rear 221 kPa (2.2 bar) (32 psi)
WEIGHT (Approximate)
With 18.3 m (60 ft) Front Fold Boom 5080 kg (11,200 lb)
18.3 (60 ft) Front Fold Boom 612 kg (1350 lb)
TRANSPORT WIDTH
18.3 (60 ft) Front Fold Boom 3.66 m (144 in.)
SPRAYING SYSTEM
T-Tank Capacity 1552 L (410 U.S gal)
V-Tank Capacity 1590 L (420 U.S. gal)
Tank Construction Polyethylene
Filler Opening Rear Lid or Optional Quick Fill
Tank Strainer Bucket Type
T-Tank Agitation Sparge Tube
V-Tank Agitation Jet
Pump Strainer Non-corrosive, "Flush Through" Type
Hose (1042 kPa (150 psi) minimum rating)
Machine Two Braid
Boom One Braid

 

AG,OUO6017,628 -19-10MAY99-3/5


SOLUTION PUMP
Type Centrifugal
Drive Belt
Speed (2400 engine rpm) 4750 rpm

 

Performance Table (Impeller at 4750 rpm at 2400 rpm Engine Speed)
NOTE: Performance figures represent amount of fluid supplied to boom without nozzles and with agitation off.
Pressure
kPa (bar) (psi)
Flow
L/min (gpm)
140 (1.4) (20) 200 (54.0)
280 (2.8) (40) 190 (50.0)
410 (4.1) (60) 170 (45.0)
550 (5.5) (80) 150 (39.0)
690 (6.9) (100) 120 (31.0)
830 (8.3) (120) 90 (23.0)
 
Item Specification
LINE STRAINER (Optional)
Location Between Electric Ball Valve and Nozzles
Type Continuous Flush
BOOM SPRAY CONTROL VALVE
Type Electric Ball Valve
Operation Right or Left Boom Switches (Center Switch-Optional)
Solution Control Electric Ball Valve (Regulator)
Pressure Gauge Digital Display
NOZZLES
18.3 m (60 ft) Front Fold (2 per 1016 mm (40 in.) Row) 36
Nozzle Width Spacing, Standard 508 mm (20 in.)
Option Variablea
Number of Sections
Standard 2
Optional 3
Operation Hydraulic Fold
aNeed conversion bundle.

 

AG,OUO6017,628 -19-10MAY99-4/5


Item Specification
OPERATOR'S CAB (Standard)
Type Air Conditioned SOUND-GARD® (No ROPS) with Deluxe Air Suspension Seat
Sound Level (in cab at 2400 rpm - stationary) 78.6 DBA
Solution Control SPRAYSTAR™
Optional Attachments AM/FM Radio
Dome Light Bulb 12-volt, Type 105 (AR86969)
Console Light Bulb 12-volt, Type 168 (AR48015)
Filter
Primary JD-AR61903
Secondary JD-AH92463
WINDSHIELD WIPER
Blade Length 508 mm (20 in.)
Arm Length 508 mm (20 in.)
AIR CONDITIONER
Make (compressor) NIPPONDENSO
Capacity 27220 kj/hr (25800 BTU/hr)
Refrigerant R-134A

 

SOUND-GARD is a trademark of Deere & Company
SPRAYSTAR is a trademark of Deere & Company

AG,OUO6017,628 -19-10MAY99-5/5