|
1.
Remove sealing tape and plastic bags from openings.
2.
Check engine oil level. If low, check for leaks. Add oil as required.
3.
Check coolant level. If low, check for leaks. Add coolant as required.
4.
Install batteries.
5.
Fill fuel tank with proper grade diesel fuel.
6.
Drain SPRAY MASTER
™
Winterizer Fluid from solution system and flush system.
7.
Start engine and warm to operating temperature. Check for leaks.
8.
Coat clean sprayer with equipment coating. (U.S.-Part No. N025703) (Canada-Part No. N207338).
9.
Clean machine thoroughly, inside and out.
10.
Check oil level in hydrostatic/hydraulic reservoir. If low, check for leaks. Add oil as required.
11.
Check tire inflation.
12.
Make sure all hardware is tight.
|
13.
Lubricate all grease fittings.
14.
Install monitor. Check that programming is correct.
15.
Close drain cock on solution pump.
16.
Install clean water in solution tank and operate system to check for leaks, before installing nozzle tips and screens.
17.
Inspect nozzle tips to make sure they are all the same size. Install tips and screens.
18.
Operate spraying system and observe spray patterns. Adjust or replace tips as necessary.
19.
Review Operator's Manual for operating adjustments and safety information.
20.
Calibrate sprayer.
21.
Check fire extinguisher gauge (if equipped) for proper charge.
22.
Check air conditioning refrigerant charge using sight glass on receiver-dryer. Have system charged if necessary.
|