Adjusting TOUCHSET Depth Control Potentiometer and Indicator

IMPORTANT: Loosen indicator strap bracket hardware before making adjustment to avoid damage to pointer strap or slotted bracket.

1. Disconnect ball joint (A) from bracket. Loosen jam nuts (B) on both rod ends.

2. Fully retract main depth control cylinder.

3. Position pointer mounting bracket so pointer tip aligns with letter F. Tighten indicator bracket hardware.

4. Pull actuator arm (C) back to contact rear stop (D). Adjust rod (E) length (as necessary) to align ball joint with hole in bracket. Tighten jam nuts.

5. Attach ball joint to bracket with nut.

A-Ball Joint
B-Jam Nuts
C-Actuator Arm
D-Rear Stop
E-Rod

NX,980J98,A13B -19-09APR98-1/1