Diagnostic Channels-3 and 4
Channel 3-Crop Sensor "Learned" Value
NOTE:
This channel is for diagnostic purposes only, there is no operator adjustment.
This channel displays "learned" values of crop sensor. System must first go through "learn mode" before values will be displayed.
This channel can be used to ensure that input signal coming from crop sensor is valid. This channel can be monitored while driving machine through field.
Exit calibration mode by turning OFF ROW-TRAK
™
switch. To change channels, push CAL/LEARN switch into CAL position (push down on upper half of switch) and rotate "Offset" knob to change channels as desired, then release CAL/LEARN switch.
Channel 4-Rear Wheel Sensor "Learned" Value
NOTE:
This channel is for diagnostic purposes only, there is no operator adjustment.
This channel displays "learned" value of rear wheel sensor. System must first go through "learn mode" before values will be displayed.
This channel can be used to ensure that input signal coming from rear wheel sensor is valid. This channel can be monitored while driving machine through field.
Exit calibration mode by turning OFF ROW-TRAK
™
switch. To change channels, push CAL/LEARN switch into CAL position (push down on upper half of switch) and rotate "Offset" knob to change channels as desired, then release CAL/LEARN switch.
|