|
ROW-TRAK
™
guidance system allows operator hands-off steering of machine by aligning row units with rows and then activating a switch on hydro lever.
At the end of row, turning steering wheel will deactivate system and return manual control of machine. After system has been deactivated, operator must repeat row alignment and switch activation procedures to activate ROW-TRAK
™
system.
See Operating ROW-TRAK
™
in this section for detailed description of operation.
If the ROW-TRAK
™
system is installed at factory or by dealer, all set-up programming and diagnostics are performed at factory or dealer prior to machine delivery.
Channels 1 and 2 modify ROW-TRAK
™
response of machine. Channel 5 establishes an automatic valve set-up that records level of supply voltage where steering valve starts to turn guide tires. Channels 3, 4, and 6-10 are used for diagnosing problems on machine. For descriptive information see Performance
|
Channels-1 and 2, Perform ROW-TRAK
™
Automatic Valve Biasing-Channel 5, and Diagnostic Channels-3, 4, and 6-10.
NOTE:
Channels 1-10 are only used during diagnosing and correcting ROW-TRAK
™
performance problems. Refer to ROW-TRAK
™
in Troubleshooting section of this manual for details.
Operation and set-up procedures in this section include:
-
Operating ROW-TRAK
™
-
Field ROW-TRAK
™
Learn
-
Static ROW-TRAK
™
Learn
-
Entering ROW-TRAK
™
Calibration Mode
-
Performance Channels- 1 and 2
-
Diagnostic Channels-3 and 4
-
Perform ROW-TRAK
™
Automatic Valve Biasing-Channel 5
-
Diagnostic Channels-6-10
-
ROW-TRAK
™
Circuit Diagnostic Codes
|